When you plan more openings, Set - 10 number of girdles Tonar D210mm/D85mm gives ten identical positions for working with live bait. The set is aimed at fishing for pike, perch and white fish on ice. This saves the collection of individual pieces, but requires that you have prepared enough holes and be able to monitor each flag.
Consider the effigy and the ice-cover. For this kit, a 130–150 mm diameter was recommended so that removing a larger specimen would be easier. The single option is reasonable if you are just arranging tackle or hunting in few positions; the ten pieces make sense when the organization of the holes and bait has already been clarified.
On the ice first clean the edge of the opening, place the base evenly and check that the stand does not tilt. Turn the reel by hand, adjust the screw and only then load the rig. The flag should be released distinctly without the spring stick resting on other parts. This will distinguish the actual spin from a problem in the setup itself.
After the outing, remove ice and moisture from the base, pulley, screw and spring signalizer. Allow the parts to dry disassembled as far as the construction allows, and inspect the flag before the next exit. The typical mistake is to put everything away frozen: then regulation is difficult to check at home, and the problem is only found on the ice.
On the ice, it is good to consider the celebs along with the rest of the equipment, so start from Accessories for ice fishing Fishing. For the fishing rods, departments next review in Rods for sub-icing, and the organization of the small tackle continued through Cans for sub-icingbefore you put the whole set together for the outing.